#include <p18f252.h>
#include <stdlib.h>
#include <delays.h>
#include <usart.h>






#pragma config OSC = HSPLL										//16MHz
#pragma config WDT = OFF, PWRT = ON

#pragma config LVP = OFF										// must be OFF for HSKA Pic eval board								
#pragma config BORV = 42



void main( void )
{
 unsigned char z;


 // TRISC=0b10001001;
  TRISB=0;
  TRISA=0b00000000;
 // configure software UART
	OpenUSART(	USART_TX_INT_OFF 	&
		 		USART_RX_INT_OFF 	&
				USART_ASYNCH_MODE 	&
				USART_EIGHT_BIT 	&
				USART_CONT_RX 		&
				USART_BRGH_HIGH, 207); //1200 Bd

LcdInit();
Delay_ms(50);
LcdPutrs("Wert:");
Delay_ms(50);

  while( 1 )
   {
        		
       
	    z = ReadUSART(); //read a byte
		
   		Delay_ms(50);
   		WriteUSART( z ); //bounce it back
        
    	LcdPutc(z);

  }
}