1.2.BF.6.0 - reengineered the trigger control - added new OSOZ capture trigger hardware API - added new trigger mode "Free Run" - new trigger level correction for more precise trigger level - repaired pulsewidth trigger - made all trigger modes available for pulswidth trigger known issues: - at pulsewidth triggering "><" (pulsewidth between) the signal may freeze if the pulswidth of the signal is falling lower than the lower threshold which is adjusted. This happens with normal-trigger only. In this case combi-trigger or auto-trigger are recommended! 1.2.BF.6.0 C2 - fixed wrong source channel entry in edge trigger source menu after default setup 1.2.BF.6.1 - changed external trigger API to actual OSOZ API - reengineered and corrected TV trigger -> seems to work now ok Attention!!! Attention!!! Attention!!! Attention!!! Attention!!! If You are upgrading from version 1.2.BF.5.7 or earlier: At the first start of the new firmware there will appear a popup with progress indicator that informs You about writing the new FFT tables into flash. This may take 10 minutes. Don't switch off Your DSO, take a coffee and wait until it is done. If You interrupt this process it will appear again at the next startup until it is completely finshed. After that it won't appear again. For further details please read the changelog and the file Special Functions.txt Please don't forget to make a default setup and check your calibration after flashing! Hayo