1.2.BF.6.0 - reengineered the trigger control - added new OSOZ capture trigger hardware API - added new trigger mode "Free Run" - new trigger level correction for more precise trigger level - repaired pulsewidth trigger - made all trigger modes available for pulswidth trigger known issues: - at pulsewidth triggering "><" (pulsewidth between) the signal may freeze if the pulswidth of the signal is falling lower than the lower threshold which is adjusted. This happens with normal-trigger only. In this case combi-trigger or auto-trigger are recommended! 1.2.BF.6.0 C2 - fixed wrong source channel entry in edge trigger source menu after default setup 1.2.BF.6.1 - changed external trigger API to actual OSOZ API - reengineered and corrected TV trigger -> seems to work ok now 1.2.BF.6.3 - activated VSync interupt for delayed function calls - on screen status which displays some important parameters - changed channel coupling button behaviour, AC/DC is changed by direct push, GND is available with multiple pushes, - some fixes and optimizations 1.2.BF.6.4 - changed flash sector mapping !!!!!! You will loose all Your settings -> calibration must be done !!!!!! - new variable gain adjusting in hardware menu - corrected IIR cutoff frequencies in OSS - optimized ADC-readout sequence for FFT - changed channel coupling button logic - corrected QM voltage measuring - increased speed in the fast timebases incl. interpolated timebases by factor 2 1.2.BF.6.4 C2 - fixed bug in calibration routine 1.2.BF.6.4 C3 - fixed bug in calibration routine -> corrected channel index 1.2.BF.6.4 C4 - fixed bug in Run/Stop and Save/Recall procedure - saving channel 4 delay fixed - saving calibration set fixed 1.2.BF.6.4 C5 - fixed bug in Single Shot at interpolated timebases (20ns - 2ns) - fixed saving channel delay using main wheel - fixed FFT memory bug Attention!!! Attention!!! Attention!!! Attention!!! Attention!!! If You are upgrading from version 1.2.BF.5.7 or earlier: At the first start of the new firmware there will appear a popup with progress indicator that informs You about writing the new FFT tables into flash. This may take 10 minutes. Don't switch off Your DSO, take a coffee and wait until it is done. If You interrupt this process it will appear again at the next startup until it is completely finshed. After that it won't appear again. For further details please read the changelog and the file Special Functions.txt Please don't forget to make a default setup and check your calibration after flashing! Hayo