#include "xc.h"
        
// FBS
#pragma config BWRP = OFF               // Boot Segment Write Protect (Disabled)
#pragma config BSS = OFF                // Boot segment Protect (No boot program flash segment)

// FGS
#pragma config GWRP = OFF               // General Segment Write Protect (General segment may be written)
#pragma config GSS0 = OFF               // General Segment Code Protect (No Protection)

// FOSCSEL
#pragma config FNOSC = PRI              // Oscillator Select (Primary Oscillator (XT, HS, EC))
#pragma config SOSCSRC = DIG            // SOSC Source Type (Analog Mode for use with crystal)
#pragma config LPRCSEL = HP             // LPRC Oscillator Power and Accuracy (High Power, High Accuracy Mode)
#pragma config IESO = ON                // Internal External Switch Over bit (Internal External Switchover mode enabled (Two-speed Start-up enabled))

// FOSC
#pragma config POSCMOD = EC             // Primary Oscillator Configuration bits (External clock mode selected)
#pragma config OSCIOFNC = OFF           // CLKO Enable Configuration bit (CLKO output disabled)
#pragma config POSCFREQ = HS            // Primary Oscillator Frequency Range Configuration bits (Primary oscillator/external clock input frequency greater than 8MHz)
#pragma config SOSCSEL = SOSCHP         // SOSC Power Selection Configuration bits (Secondary Oscillator configured for high-power operation)
#pragma config FCKSM = CSDCMD           // Clock Switching and Monitor Selection (Both Clock Switching and Fail-safe Clock Monitor are disabled)

// FWDT
#pragma config WDTPS = PS32768          // Watchdog Timer Postscale Select bits (1:32768)
#pragma config FWPSA = PR128            // WDT Prescaler bit (WDT prescaler ratio of 1:128)
#pragma config FWDTEN = OFF              // Watchdog Timer Enable bits (WDT enabled in hardware)
#pragma config WINDIS = OFF             // Windowed Watchdog Timer Disable bit (Standard WDT selected(windowed WDT disabled))

// FPOR
#pragma config BOREN = BOR3             // Brown-out Reset Enable bits (Brown-out Reset enabled in hardware, SBOREN bit disabled)
#pragma config LVRCFG = OFF             //  (Low Voltage regulator is not available)
#pragma config PWRTEN = ON              // Power-up Timer Enable bit (PWRT enabled)
#pragma config I2C1SEL = PRI            // Alternate I2C1 Pin Mapping bit (Use Default SCL1/SDA1 Pins For I2C1)
#pragma config BORV = V18               // Brown-out Reset Voltage bits (Brown-out Reset set to lowest voltage (1.8V))
#pragma config MCLRE = ON               // MCLR Pin Enable bit (RA5 input pin disabled,MCLR pin enabled)

// FICD
#pragma config ICS = PGx1               // ICD Pin Placement Select bits (EMUC/EMUD share PGC1/PGD1)

// FDS
#pragma config DSWDTPS = DSWDTPSF       // Deep Sleep Watchdog Timer Postscale Select bits (1:2,147,483,648 (25.7 Days))
#pragma config DSWDTOSC = LPRC          // DSWDT Reference Clock Select bit (DSWDT uses Low Power RC Oscillator (LPRC))
#pragma config DSBOREN = ON             // Deep Sleep Zero-Power BOR Enable bit (Deep Sleep BOR enabled in Deep Sleep)
#pragma config DSWDTEN = ON             // Deep Sleep Watchdog Timer Enable bit (DSWDT enabled)