U-Boot 2011.09-00000-gf54ce7f-dirty (Dec 20 2011 - 12:36:29)

DRAM:  128 MiB
NAND:  NAND device: Manufacturer ID: 0xad, Chip ID: 0x76 (Hynix NAND 64MiB 3,3V 8-bit)
64 MiB
Bad block table at page 1120, version 0x01
Bad block table at page 1152, version 0x01
nand_read_bbt: Bad block at 0x0000003d0000
nand_read_bbt: Bad block at 0x0000031b8000
In:    serial
Out:   serial
Err:   serial
Net:   natsemi: EEPROM contents:
 d008 0400 0b34 00f3 0000 0000 0000 8c00 c8f9 4c41 0000 aa70
natsemi: MAC-Address: 0:18:F3:91:83:98
dp83815#0

Welcome to the pollinux board v1.1

Hit any key to stop autoboot:  0 
# printenv
addip=setenv bootargs $(bootargs) ip=$(ipaddr)
baudrate=38400
bootargs=console=ttyS1,38400n8 stb810_display=pal nomainapp=1 root=/dev/sda1 rw ip=192.168.0.105:192.168.0.1:192.168.0.1:255.255.255.0:vdrdvbc:eth0:off:8.8.8.8:8.8.4.4ip)
bootcmd=run nandboot
bootdelay=2
bootfile=/pollinux/nandfs/boot/uImage
ethact=dp83815#0
ethaddr=00:00:00:00:00:00
gatewayip=192.168.0.1
hostname=pollinux
ideargs=setenv bootargs $(bootargs) root=$(rootdev) rw
ideboot=sata init;ext2load sata 0:1 $(loadaddr) $(bootfile);run ideargs addip;bootm
ip=192.168.0.105:192.168.0.1:192.168.0.1:255.255.255.0:vdrdvbc:eth0:off:8.8.8.8:8.8.4.4
ipaddr=192.168.0.105:192.168.0.1:192.168.0.1:255.255.255.0:vdrdvbc:eth0:off:8.8.8.8:8.8.4.4
la=80100000
ld=loadb $(la);sleep 5;go $(la)
loadaddr=0x82000000
mtddevname=FlashReader
mtddevnum=0
mtdids=nand0=nxp-0
mtdparts=mtdparts=nxp-0:16k(FlashReader)ro,512k(U-Boot),32k(Env),32k(bbt),9M(Linux),50M(ROMFS),4080k@0x3c00000(WinCE)ro,16k(info)ro
nandboot=mtdparts default;nboot Linux;bootm
netmask=255.255.255.0
nfsargs=setenv bootargs $(bootargs) root=/dev/nfs rw nfsroot=$(serverip):$(rootpath)
nfsboot=nfs "$(serverip):$(bootfile)";run nfsargs addip;bootm
partition=nand0,0
pollinux=vdrdvbc2
preboot=echo;echo Welcome to the pollinux board v1.1;echo
rootdev=/dev/sda1
rootpath=/pollinux/nandfs
serverip=192.168.0.1
stderr=serial
stdin=serial
stdout=serial

Environment size: 1447/4091 bytes
#