WordClock Change Log
====================

V 0.10 (339)
  * abschaltbares "ES IST" via Sprach-Wahl-Taste (beide deutsche Front designs)
    (bernommen von wichtel - aber Reihenfolge gendert -> Handbuch)
  * Bootloader Support:
    Wenn 'R' ber die UART empfangen wird, wird ein Watchdog-Reset ausgelst.
    Der Watchdog wird direkt nach Systemstart deaktiviert.
  * Indikator fr Zeiteingabe definiert -> blinkendes 'Uhr', wenn keine Minutenwrter aktiv
  * Helligkeit fr Nachtstunden bei Zeiteingabe reduziert.
  * Sicherung des Hauptmodus (Einfarb-, Farbwechsel- und Pulse-Modus) und des aktiven Farbprofils im EEPROM
  * BAUD_ERROR Makro aktualisiert
  * atmega88 Konfiguration entfernt
  * DCF77 gendert, zwei erfolgreich empfangene Frames vor Zeitbernahme notwendig
  * IRMP-Version 1.7.2: Bugfix: Timeout vor NEC repetition frames um "Geister-Kommandos" zu vermeiden
                        einige weniger wichtige Protokolle hinzugefgt
  * gefixt BUG09_018 (Zeitupdate whrend Zeiteingabe beintrchtigt Anzeige)
  * gefixt BUG09_019 (gemeldet von Wichtel) ("Gesiter-Kommandos" siehe neue IRMP-Version)
  * gefixt BUG09_020 (gemeldet von Roman) DCF-Initialisierung <=6 anstatt <=7
  * gefixt BUG09_021 (Ambilight in SW an OUTG2 anstatt OUTG1)
  * gefixt Fehler der in Mono-Color-Variante: zurckschalten in Normal-Mode forciert kein Display-Update




complete (mixed english/german)

V 0.10 (339)
    * deactivatable "ES IST" via display mode key (both german front designs)
      (merge from wichtel - but changed order)
    * Bootloader Support:
      If 'R' was received via UART, the Watchdog will be enabled to reset the device.
      The wdt is deactivated right after system start up.
    * added a Set-Time-Indicator (hour for word clock) to signalize 
      Set-Time-Mode if no minute word is active
    * reduced brightness for night hours in set time mode
    * save main mode (normal, fade, pulse) and active color preset
    * change BAUD_ERROR macro
    * removed atmega88 configuration
    * DCF77 changed, so that two successful received frames are now needed,
      befor the dcf time will be taken over
    * IRMP-Version 1.7.2: bugfix: added timeout for NEC repetition frames to avoid "ghost commands"
                          added some (less relevant) protocols

    * fixed BUG09_018 (while entering time a timeupdate destroys current display)
    * fixes BUG09_019 (reported by Wichtel) (new IRMP-Version)
    * fixed BUG09_020 (reported by Roman) DCF-Initialisierung <=6 instead <=7
    * fixed BUG09_021 (Ambilight connected to OUTG2 in SW instead of OUTG1)
    * fixed bug that occurs in mono color if switched back to normal mode 
      -> no update of display was done

V 0.9 Patch 5
    * fixed BUG09_017 (set second to 0, when new DCF77 time will take over - prevent a minute jump) 
V 0.9 Patch 4 (312)
    * fixed BUG09_015 (after enter OnOff-Time no further action is possible)
    * fixed BUG09_016 (last Ir-Command is ignored in training) 
V 0.9 Patch 3 (311)
    * fixed BUG09_009 (crashes after IR-Kommands)
    * fixed BUG09_011 (training bug)
    * fixed BUG09_012 (casing on include usermodes.c)
    * fixed BUG09_013 (1:00 - 1:04 and 1:05-1:09 's')
    * fixed BUG09_014 (brightness control does not work after setting time)
    * fixed wrong command handler in display_x-header
    * fixed default values for color profiles
    * extracted inits of states from user_init to own routine in usermodes.c 
V 0.9 Patch 2 (302)
    * fixt BUG09_010 (EIN <-> EINS) 
V 0.9 Patch 1 (300)
    * fixt BUG09_008 (falsche Zeitanzeige) 
V 0.9  (298)
    * Untersttzung fr neue (3 sprachige) deutsche Front
    * Untersttzung fr TIX-Clock
    * kurze Anzeige von Submodi (Farbprofilauswahl, Sprachvariante)
    * Helligkeits-Offset wird abgespeichert
    * 24h Zeiteingabe (8-20Uhr: hell, 20-8Uhr: dunkel)
    * Standardeeprom-Werte im Flash
    * Ein/Aus-Schalt-Zeiten
    * Pulsierender Modus
    * neue IRMP-Version 


