-
PDF
AVRISPmkII_UG.pdf
will prompt the user to upgrade AVRISP mkII The following devices are supported: Tiny Mega Other ATtiny12 ATmega48 AT86RF401 ATtiny13 ATmega8 AT89S51 ATtiny15 ATmega88 AT89S52 ATtiny22 ATmega8515 AT90PWM2 ATiny2313 ATmega8535 AT90PWM3 ATtiny24 ATmega16 AT90CAN32 ATtiny26 ATmega162 AT90CAN128 ATtiny45
in „AVRISP mkII - 10-polig?“ · Mikrocontroller und Digitale Elektronik ·
-
PDF
AVR053.pdf
Grouped by oscillator version. Oscillator version Device RC oscillator frequency [MHz] CKDIV PRSCK 1.1 ATtiny12 1.2 1.2 ATtiny15 1.6 2.0 ATmega163 1.0 2.0 ATmega323 1.0 3.0 ATmega8 1.0, 2.0, 4.0, and 8.0 3.0 ATmega16 1.0, 2.0, 4.0, and 8.0 3.0 ATmega32 1.0, 2.0, 4.0, and 8.0 (1) 3.1 ATmega64 1.0, 2.0, 4.0,
in „OSCCAL für 8MHz ?!? be ATTiny26“ · Mikrocontroller und Digitale Elektronik ·
-
PDF
doc8002.pdf
8MHz is offered in version 4.0. For later 4.x versions, two frequencies are offered: 4 and 8MHz for ATtiny2313, and 4.8 and 9.6MHz for the ATtiny13. The OSCCAL register is changed so that only 7 bits are used to tune the frequency for the selected oscillator. The MSB is not used. Auto loading of the default
in „Genauigkeit interner Oszillator Mega8 ...“ · Mikrocontroller und Digitale Elektronik ·
-
PDF
doc4298.pdf
AVR091: Replacing AT90S2313 by ATtiny2313 Features 8-bit • AT90S2313 Errata Corrected in ATtiny2313 Changes to Bit and Register Names Microcontrollers Changes to Interrupt Vector Oscillators and Selecting Start-up Delays Improvements to
in „tiny2313-90S2313“ · Mikrocontroller und Digitale Elektronik ·
-
PDF
AVR120.pdf
must stay between GND and AV . CC Note that some devices cannot measure negative differences, e.g. ATtiny26. The need for calibration The total error of the actual ADC comes from more than just quantization error. This document describes offset and gain errors and how to compensate for them. It also describes
in „ATtiny15 ADC differential“ · Mikrocontroller und Digitale Elektronik ·
-
PDF
AVR450_BattCharger.pdf
includes two separate battery chargers. One using AT90S4433 AVR microcontroller and one using the ATtiny15 AVR microcontroller. The AT90S4433 design demonstrates how efficient a battery charger can be implemented with C-code. The ATtiny15 design shows the highest integrated and lowest cost battery charger
in „Pb-Akku Ladegerät mit µP Selbstgemacht“ · Mikrocontroller und Digitale Elektronik ·
-
PDF
EMC_Design_Consideration_AVR_doc1619.pdf
optimum Reset behavior. The diode must also be omitted if In-System Programming of devices like ATtiny11, which can only be programmed using 12V, is required. Then one of the ESD protection methods described earlier may be used instead. Figure 10. Recommended Reset Pin Connection Vcc R Microcontroller
in „Servo Ansteuerung mit ATMega128“ · Mikrocontroller und Digitale Elektronik ·
-
PDF
DOC1619.PDF
optimum Reset behavior. The diode must also be omitted if In-System Programming of devices like ATtiny11, which can only be programmed using 12V, is required. Then one of the ESD protection methods described earlier may be used instead. Figure 10. Recommended Reset Pin Connection Vcc R Microcontroller
in „Spannungsstabilisierung/Entstörung“ · Analoge Elektronik und Schaltungstechnik ·
-
PDF
AVR911.pdf
that use slightly different algorithms are not supported. This applies to the following devices: ATtiny12, ATtiny15, ATtiny26, ATtiny2313, AT90S1200, AT90S2313, AT90S2323/2343, AT90S4433, AT90S8515 and AT90S8535. The bootloader module of AVROSP supports all devices with bootloader capabilities. Note: ATtiny11 and ATtiny28 do not support ISP or bootloader programming, and are not supported by AVROSP. The user could customize the code to support other programmers, e.g. a serial high-voltage programmer.
in „AVR911: Das Ende aller Leiden?“ · Mikrocontroller und Digitale Elektronik ·
-
PDF
AVR309_doc2556.pdf
The USB bus is quite fast: LowSpeed - 1.5Mbit/s, FullSpeed - 12Mbit/s, HighSpeed - 480Mbit/s. The ATtiny2313/ATmega48/88/168 are fully capable of meeting the hard speed requirements of LowSpeed USB. The solution is however not recommended for higher USB speeds. Theory of Operation Extensive details regarding
in „Programmer incl. neuem Code für Atmel AN910“ · Projekte & Code ·
-
PDF
avr450.pdf
closer to the maximum capacity of the battery. Improved ler and the highly integrated low-cost 8-pin ATtiny15 resolution also eliminates the need for external Op-amps to microcontroller, however, it can be implemented using any "window" the voltage. The result is reduced board space AVR microcontroller with
-
PDF
AVR_ISP_USER_GUIDE.PDF
that the firmware in the pro- grammer is outdated. The following devices are currently supported: ATtiny12 ATtiny15 ATtiny22 AT90S1200 AT90S2313 AT90S/LS2323 AT90S/LS2343 AT90S/LS2333 AT90S4414 AT90S/LS4433 AT90S/LS4434 AT90S8515 AT90S/LS8535 ATmega161(L) ATmega16(L) ATmega163(L) ATmega32(L) ATmega323