-
PDF
at42qt1070.pdf
FI2C I C clock rate – – 400 kHz – Fm Burst modulation, ±8 % – percentage RESET pulse width 5 – – µs – AT42QT1070 [DATASHEET] 23 9596C–AT42–05/2013 6.6 Mechanical Dimensions 6.7 AT42QT1070-SSU – 14-pin SOIC AT42QT1070 [DATASHEET] 24 9596C–AT42–05/2013 6.8 AT42QT1070-MMH – 20-pin 3 × 3 mm VQFN AT42QT1070
in „QTOUCH Controller Atmel AT42QT1070 Timing Problem bei I2C ?“ · Mikrocontroller und Digitale Elektronik ·
-
Datei
ATB_Touch_Prg_1.c
ATB_Touch_Prg_1.c Created: 27.03.2016 17:37:48 Author : AS */ // Hardware // D2 - Display I2C, P92 - AT42QT1070 // P30 - Board 1 mit AT1284p, NT2 mit 5/12V 3A #include <stdbool.h> #include <avr/pgmspace.h> #include "main.h" #include <util/delay.h> #include "i2clcd.h" #include "i2cmaster.h" #include "avr
in „AT42QT1070 - QTouch für das Modulare Board“ · Mikrocontroller und Digitale Elektronik ·
-
PDF
TEKTRONIX_Component_Service_Manual_TDS_520B_Mod_CM_Digitizing_Oscilloscope_070-9710-03.pdf
ramp at the rate set by the R?C timing components until another sync signal occurs. (in the absence of sync, the generator will reset itself at a predetermined level and the scan will “free-run” at a slightly
in „Tektronix TDS744A Netzteil“ · Analoge Elektronik und Schaltungstechnik ·
-
Datei
config-mod-LK511-mt7623n-BPiR2.txt
CONFIG_KEYBOARD_ADP5588 is not set # CONFIG_KEYBOARD_ADP5589 is not set CONFIG_KEYBOARD_ATKBD=m # CONFIG_KEYBOARD_QT1070 is not set # CONFIG_KEYBOARD_QT2160 is not set # CONFIG_KEYBOARD_DLINK_DIR685 is not set # CONFIG_KEYBOARD_LKKBD is not set CONFIG_KEYBOARD_GPIO=m # CONFIG_KEYBOARD_GPIO_POLLED is not set # CONFIG_KEYBOARD_TCA6416
in „Linux Kernel 5.1.1. auf dem BPi-R2“ · PC Hard- und Software ·