Kann nicht Flashen

> "make.exe" program

avrdude -p attiny26 -P lpt1     -c stk200    -U

flash:w:belichtungstimer.hex 

avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100%

0.00s

avrdude: Device signature = 0x1e9109

avrdude: NOTE: FLASH memory has been specified, an erase cycle will be

performed

         To disable this feature, specify the -D option.

avrdude: erasing chip

avrdude: reading input file "belichtungstimer.hex"

avrdude: input file belichtungstimer.hex auto detected as Intel Hex

avrdude: writing flash (1404 bytes):

Writing | ################################################## | 100%

0.79s

avrdude: 1404 bytes of flash written

avrdude: verifying flash memory against belichtungstimer.hex:

avrdude: load data flash data from input file belichtungstimer.hex:

avrdude: input file belichtungstimer.hex auto detected as Intel Hex

avrdude: input file belichtungstimer.hex contains 1404 bytes

avrdude: reading on-chip flash data:

Reading | ################################################## | 100%

0.57s

avrdude: verifying ...

avrdude: verification error, first mismatch at byte 0x0000

         0x0b != 0x00

avrdude: verification error; content mismatch

avrdude: safemode: lfuse changed! Read as 0, was e4

avrdude: and COULD NOT be changed

avrdude: safemode: hfuse changed! Read as 0, was 17

avrdude: and COULD NOT be changed

avrdude: safemode: Fuses not recovered, sorry

avrdude done.  Thank you.

make.exe: *** [program] Error 1

> Process Exit Code: 2