PIC 18F2585 automatisches RESET

#include "D:\Projeckte\OpenBMS\test.h"

 int32 c;

void main()

{

   setup_adc_ports(AN0_TO_AN9|VSS_VREF);

   setup_adc(ADC_CLOCK_DIV_32|ADC_TAD_MUL_20);

   setup_spi(FALSE);

   setup_wdt(WDT_OFF);

   setup_timer_0(RTCC_INTERNAL);

   setup_timer_1(T1_DISABLED);

   setup_timer_2(T2_DISABLED,0,1);

   setup_vref(FALSE);

   setup_oscillator(False);

   // TODO: USER CODE!!

  c=0; 

  output_high(PIN_B0);

  while(1)                          

  {   

  c++;  

  output_high(PIN_C5);

   printf("+%ld\r\n",c);

   delay_ms(500);    

   output_low(PIN_C5);

   delay_ms(500);

  }

}

#include <18F2585.h>

#device adc=16

#FUSES NOWDT                    //No Watch Dog Timer

#FUSES WDT128                   //Watch Dog Timer uses 1:128 Postscale

#FUSES HS                       //High speed Osc (> 4mhz)

#FUSES NOPROTECT                //Code not protected from reading

#FUSES NOBROWNOUT               //No brownout reset

#FUSES BORV21                   //Brownout reset at 2.1V

#FUSES NOPUT                    //No Power Up Timer

#FUSES NOCPD                    //No EE protection

#FUSES STVREN                   //Stack full/underflow will cause reset

#FUSES NODEBUG                  //No Debug mode for ICD

#FUSES LVP                      //Low Voltage Programming on B3(PIC16) or B5(PIC18)

#FUSES NOWRT                    //Program memory not write protected

#FUSES NOWRTD                   //Data EEPROM not write protected

#FUSES IESO                     //Internal External Switch Over mode enabled

#FUSES FCMEN                    //Fail-safe clock monitor enabled

#FUSES PBADEN                   //PORTB pins are configured as analog input channels on RESET

#FUSES BBSIZ4K                  //4K words Boot Block size

#FUSES NOWRTC                   //configuration not registers write protected

#FUSES NOWRTB                   //Boot block not write protected

#FUSES NOEBTR                   //Memory not protected from table reads

#FUSES NOEBTRB                  //Boot block not protected from table reads

#FUSES NOCPB                    //No Boot Block code protection

#FUSES LPT1OSC                  //Timer1 configured for low-power operation

#FUSES MCLR                     //Master Clear pin enabled

#FUSES NOXINST                  //Extended set extension and Indexed Addressing mode disabled (Legacy mode)

#use delay(clock=20000000)

#use rs232(baud=9600,parity=N,xmit=PIN_C6,rcv=PIN_C7,bits=8)