Gast
#5544302
Guten Nachmittag, habe mir eben das Dokument en.DM00051986.pdf von ST durchgelesen. Und ich weiß jetzt nicht was ich jetzt tun soll. Wie ist dieser Abschnitt gemeint? Ground and power supply (VDD, VDDA, VDDIO2) Every block (noisy, low-level sensitive, digital, etc.) should be grounded individually and all ground returns should be to a single point. Loops must be avoided or have a minimum area. In order to improve analog performance, you must use separate supply sources for VDD/ VDDIO2 and VDDA, and place the decoupling capacitors as close as possible to the device. The power supplies should be implemented close to the ground line to minimize the area of the supplies loop. This is due to the fact that the supply loop acts as an antenna, and is therefore the main transmitter and receiver of EMI. All component-free PCB areas must be filled with additional grounding to create a kind of shielding (especially when using single-layer PCBs). Ich hatte vor einen Spannungsregler zu haben und jedem Versorgung Pin einen 100n Kerko zu spendieren. Wollte die inneren Lagen für 3,3V Fläche und die andere für Masse verwenden. Ist das in Ordnung oder was wäre besser und richtiger?