Microcontroller with LabVIEW

[Broka T. (Firma: Inkel) (tutu12)]

Hi All,



I am thinking to start working on microcontroller with LabVIEW.



Recently I have done with my CLD exam.( So, I can say that I have a 
developer level knowledge)

Can anyone suggest me the best start to use LabVIEW on microcontroller?? 
Controller I am familier with are 8051 and ARM mini 2440 ( during my 
graduation I used for my final project)





Best Regards,
Mikiko

[Purzel H. (hacky)]

It doesn't matter. Labview uses an ASCII based command set, such as

V?;
or U=33.4V;

I believe commands are terminated by semicolon and carriage return & 
linefeed, but may be wrong.

Now look that up, meaning the schematic of it, and implement it.

[Johnny B. (johnnyb)]

Broka T. schrieb:
> Can anyone suggest me the best start to use LabVIEW on microcontroller??

The best start would be to not even start.
Run LabView on a microcontroller doesn't make any sense. Better run 
LabView on a fast computer and just do the realtime stuff (acquisition) 
on a microcontroller.

[Purzel H. (hacky)]

I understood Labview running on the PC should connect to a 
microcontroller. Everything else is meaningless anyway. Even if Labview 
was available in sourcecode.