Hallo an alle! Ich hab ein Problem. Mein ISP funktioniert nicht mehr. Ich habeenen STK200 kompatiblen Programmer (mit 74HCT244). Beim Flashen über WinAvr bekomme ich immer diese Fehlermeldung:
1 | > "make.exe" program |
2 | avrdude -p atmega168 -P lpt1 -c stk200 -U flash:w:rechner.hex |
3 | |
4 | avrdude: AVR device initialized and ready to accept instructions |
5 | |
6 | Reading | ################################################## | 100% 0.00s |
7 | |
8 | avrdude: Device signature = 0x1e9406 |
9 | avrdude: NOTE: FLASH memory has been specified, an erase cycle will be performed |
10 | To disable this feature, specify the -D option. |
11 | avrdude: erasing chip |
12 | avrdude: AVR device not responding |
13 | avrdude: reading input file "rechner.hex" |
14 | avrdude: input file rechner.hex auto detected as Intel Hex |
15 | avrdude: writing flash (3738 bytes): |
16 | |
17 | Writing | ################################################## | 100% 1.14s |
18 | |
19 | avrdude: 3738 bytes of flash written |
20 | avrdude: verifying flash memory against rechner.hex: |
21 | avrdude: load data flash data from input file rechner.hex: |
22 | avrdude: input file rechner.hex auto detected as Intel Hex |
23 | avrdude: input file rechner.hex contains 3738 bytes |
24 | avrdude: reading on-chip flash data: |
25 | |
26 | Reading | ################################################## | 100% 0.98s |
27 | |
28 | avrdude: verifying ... |
29 | avrdude: verification error, first mismatch at byte 0x0000 |
30 | 0x12 != 0xff |
31 | avrdude: verification error; content mismatch |
32 | |
33 | avrdude done. Thank you. |
34 | |
35 | make.exe: *** [program] Error 1 |
36 | |
37 | > Process Exit Code: 2 |
38 | > Time Taken: 00:03 |
Was ist den da los?? Kann mir da wer helfen?? Gruß Martin